Cam swap

[rob71458]

Does anyone know if any specialty tools are required to do a cam swap on a 07 110?

[Nitram_b4]

yup about 500.00 for a full set of Cam tools if I recall.
JIMS makes all the tools I would guess ya could make some of the tools yourself I always wind up making some of the tools I need for a bike

[rob71458]

Nope, All I needed was a Jims cam gear locking tool. This tool locks the crank gear to the cam gear so you can unbolt them, It also helps you time the gears. It cost about sixty bucks. Pretty easy job, now that the 2007's come with hydraulic chain tensioners. Off to the tuner for a remap.

[Nitram_b4]

Nope, All I needed was a Jims cam gear locking tool. This tool locks the crank gear to the cam gear so you can unbolt them, It also helps you time the gears. It cost about sixty bucks. Pretty easy job, now that the 2007's come with hydraulic chain tensioners. Off to the tuner for a remap.

How ya pull the bearings?

[rob71458]

Bike only had 1700 miles, I left them alone. If it had higher mileage, you would have a good point.