I dropped off my bike at Rosa's today and decided to go with 106"
He's porting my heads and putting in Woods TW 5-6 cams.
He'll also put on a free flow airfilter and TTS Master Tune.
I installed Bub 7 Stealth slip ons.
He dyno'd my stock set up with just the Bub 7 Stealths and I had 70 hp and 87 torque.
I'll post before and after dyno results when I get it back.
edit - forgot I'm getting new pushrods too.
I almost cut my hair, it happened just the other day.
It was gettin' kinda long, I could've said it was in my way.
But I didn't and I wonder why, I feel like letting my freak flag fly
You going that big and not address the crankshaft issue? Got a sneaking suspicion that you will not like the noise of the Woods cams either, their ramps are really aggressive and make more noise than anyone else's, and are very hard on the valvetrain. Hope you are doing roller rockers with them. Not busting your chops, just trying to make you aware of the pitfalls we can get into very easily.
Wanted Woman
Must be able to Clean, Sew Leather,
Tune a Harley engine, polish Chrome
Must have a Harley
Please send pic of Harley....
I asked Andrew to check the crank runout before he does anything.
I'm only doing what I listed.
I almost cut my hair, it happened just the other day.
It was gettin' kinda long, I could've said it was in my way.
But I didn't and I wonder why, I feel like letting my freak flag fly
hey cool ... there's no substitute for cubic cubes
are those cams for high rpm power rather than midrange?
Life is best experienced in the company of a woman.
Was mich nicht umbringt, macht mich stärker
I'm not here for a long time I'm here for a good time.
They are for low and midrange.
I almost cut my hair, it happened just the other day.
It was gettin' kinda long, I could've said it was in my way.
But I didn't and I wonder why, I feel like letting my freak flag fly
My bike is ready.
But I won't pick it up until tomorrow evening.
I almost cut my hair, it happened just the other day.
It was gettin' kinda long, I could've said it was in my way.
But I didn't and I wonder why, I feel like letting my freak flag fly
Oh man, wait till you twist that throttle with all them cubes.
Life is best experienced in the company of a woman.
Was mich nicht umbringt, macht mich stärker
I'm not here for a long time I'm here for a good time.
Yea man, these 96" bikes are easy to hop up big time.
I'm very much looking forward to it.
I almost cut my hair, it happened just the other day.
It was gettin' kinda long, I could've said it was in my way.
But I didn't and I wonder why, I feel like letting my freak flag fly
I wanna see numbers!!!! Ya never no I can always change cams again..........
Its a dog eat dog world and I'm wearin milkbone underware!!!!!!!!!!!!!!!!!!
I didn't ask about the #s, but hp and torque should be about 115 or 120 I think.
If it's lower than that it is because of the exhaust.
You need SE heads or similar to fit those cams in without removing the heads.
From what I have read, those cams you have are very good for low end torque anyway.
I went with what Andrew Rosa recommended because I trust him. He builds a lot of motors and gives a good warranty. He doesn't want to build something that will break.
I almost cut my hair, it happened just the other day.
It was gettin' kinda long, I could've said it was in my way.
But I didn't and I wonder why, I feel like letting my freak flag fly
Posting Permissions
Reply With Quote